3002R-H - programmable 2-channel DMX relay module - ordering code: 3002R-H
Industrial control installations make wide use of equipment which can be mounted on a standard DIN rail .
As more and more DMX equipment is being used in architectural lighting and building control systems,
we have added a DMX controlled relay module, capable of controlling two individual loads. |
2 CHANGEOVER CONTACTS
The high current rating of the changeover contacts makes this module a versatile tool for all switching needs.
Contact rating is 6 amps at 230 Volts ( resistive load ).
The combination of two individual relay outputs allows to control all types of load switching, including motor control. |
NO SWITCHES, NO JUMPERS
As xompared to devices used on stage, start address setting is not normally required in fixed installations.
Thus the 3002R-H relay module has been set up to support permanent configuration;
all settings are user-definable and are stored in non-volatile memory.
The list of programmable parameters includes:
- the DMX start address
- upper and lower trip point
- channel assignment
- HOLD mode
|
SIMPLE CONFIGURATION
To configure the 3002R-H DMX relay module, our universal programming adaptor 3000P allows direct connection to the module.
Alternatively, simply use your PC and our DMX interface card 1512B.
Free programming can be downloaded from www.pcdmx.com |
TECHNICAL DATA
2 Relays, switched individually (2 dmx channels).
Switching hysteresis 20/80% or 45/65% programmable.
DMX HOLD to hold last valid data at signal loss programmable.
DIN rail module approx. 83 mm
Switched load: 230V , 2 x 6A resistive
Power Supply: 230V AC, approx. 3W
Connectors: WAGO spring terminals.
|
