12Ch led driver 350mA-fixed

This driver controls up to 12 channels of 350 mA at a maximum of 48 V. This module can control 4 of the same RGB luminaries. Each output can be charged with up to 12 LEDS. Each output needs to be charged with the same amount of LEDS. For example 12 LEDS on every output. The power supply’s voltage can vary from 8V to 48V. The power supply itself has to be able to produce enough power to drive all LEDS. To connect the power supply we suggest you use an electrical wire with an appropriate thickness.

Because this led driver is working in a special current control way, the power supply needs to be chosen according to the amount of leds connected. If we would connect a too high voltage the heat will be dissipated and it would overheat the driver, a too low voltage simply won’t work.

The drivers’ outputs are 4X 5way Wago cage clamps. The driver has a RJ 45 connector which can be used to connect an extension trigger panel or a RF remote control, to be ordered at Lux Lumen. Two cage clamps serve to connect a NTC temperature sensor 10K ohms. When the driver reaches 60°C the output will reduce to 50%, 70°C will inactivate the outputs.

The driver should be mounted on a DIN rail. The units’ measurements are 110 by 170 mm and a height of approximately 100 mm.