LL6 - A

The LL6-A is a circular PCB with a diameter of 90mm and a whole in the middle. This product is specially developed for fountains jets.

The LL6-A has 6 Luxeon K2 Emitters: 2 x red (620,5nm), 2 x green (535 nm), 2 x royal blue (445nm).

Different optics are available to place over the leds: small (±7,9°), medium (± 19°), wide (± 32°).

A maximum 6 boards can be connected to each other when using a six wire cable. The PCB works at 350mA and should be connected to a sufficiently large cooling surface with the use of thermal paste or thermal tape.

The LL6-A prints should be connected to a Leddriver12 card. Four different chains (of maximum 6 boards) can be attached to the Leddriver12 card. Each chain can have a different colour. The alternative is to connect the LL6-A prints to a 3-channel 350mA current source.