NoFlash
SOUNDLIGHT DEMULTIPLEXER | Demux 3044B-H RDM

Demux 3044B-H RDM

This decoder converts DMX512 into 1...+10V output drive for electronic ballasts, which cannot be driven from standard 0..10V demultiplexers. Assuming a typical load of 2mA per ballast, each 50mA rated output can drive up to 25 ballasts in parallel. Also, the unit may be switched from 4-channel operation to one-channel-mode, which then would allow to drive up to 100 ballasts simultaneously. The decoder additionally features four power outputs (max 200W @ 230V AC) to switch off connected ballasts.

NOTE: The board comes without address setting pcb. If needed, a start address board (3000P or 3003P) must be ordered separately.

TECHNICAL DATA

  • Control input: DMX512
  • Control output: 4x 1...10V DC max 25mA (control output for typical 50 ballasts @ 0,5mA per ballast)
  • Supply voltage: 230V AC
  • Supply Out: 4x 230V max 200W switched output (electronic ballast supply)

Accessories:
3003P3000P
Technical Data :
 
. MANUAL 3044B-H Mk1 980 Kbytes
. MANUAL 3044B-H Mk3 RDM 139 Kbytes
Twitter! Abonneren op mij op YouTube